Cooper Security i-on160EX Guía de instalación descargar pdf (Pagina 66)

Installer Menu Options i-on160

Page 60

2. If you are unsetting a partition and setting the same partition again then

you must program the setting event to occur at least 10 minutes after the

unsetting event.

System Options

This section of the Installer Menu contains a series of options that affect the

working of the alarm system as a whole.

Note: The default settings for these options are compliant with EN50131, see

page 23. Changes to some of the defaults may render the system non-

compliant.

Wired Zone Type

Normally the control unit asks you to select the zone wiring type when you

power up a new installation for the first time, or when you restore the control

unit to factory defaults (see page 9). This sub-menu lets you change the zone

wiring type for either the control unit or for the whole system. There are two

options:

Panel This option lets you chan

e the zone wirin

type for the control

unit.

System This option lets you change the zone wiring type for the whole

system.

For both options the choices available are: 4-wire CC, 4k7/2k2. 1k0/1k0,

2k2/2k2, or 4k7/4k7.

If you select “4 Wire CC” then the control unit and/or expanders provide five

wired zones, numbered 1 to 5.

There are several options of resistor values for FSL: the keypad display shows

the alarm contact resistor/end of line resistor values for each option.

If you select any of the Panel - FSL options then the control unit provides 10

wired zones, numbered 0 to 9.

If you select any of the System – FSL options then all wired expanders provide

10 wired zones, number 0 to 9.

You can change the wiring type of each wired expander individually, see page

40.

Note: Make sure that all zones are wired correctly for the selected wiring type.

See i-on160EX Installation Guide for wiring details.

User Access

To give users access to various system facilities select System Options – User

Access. Press the u or n keys to scroll up or down the list on the display. To

allow access press > repeatedly until “Yes” appears next to the selected

option. To deny access press > until “No” appears next to the selected option.

Press Y when you have finished.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 179 180

Comentarios a estos manuales

Sin comentarios

Cooper Security i-on160EX Guía de instalación Pagina 66

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper Security i-on160EX