Cooper Security i-on160EX Guía de instalación descargar pdf (Pagina 169)

i-on160 Appendix III

Page 163

Teach the WAM the Identity of the Detectors

1. Enter programming mode as follows:

a) Open the tamper switch.

The Red Trouble LED glows.

b). Press SELECT.

The blue LED 1 glows. The WAM is in menu 1.

2. Press SET.

If any blue LEDs flash then those channels are

already in use.

3. Activate tampers on all transmitters that the WAM

needs to learn.

Each time the WAM learns a detector a blue LED

glows to show the channel that detector is using.

4. Leave programming mode as follows:

a) Leave menu 1 by pressing ESC.

The blue LED 1 glows steadily.

b) Press ESC a

ain.

The blue LED 1 goes dark. The sounder gives a

regular beeping tone to remind you to replace the

lid.

c) Close the lid tamper.

After a few seconds the WAM bleeps twice and the

red Trouble LED goes dark.

NOTE: You must leave programming mode in order to

save the changes you have made.

5. Check that the control unit can receive signals

from the transmitters learned by the WAM.

Deleting Devices

If you need to delete detectors from a WAM, perhaps in order to move them

from one repeater to another, then:

1 2 ... 164 165 166 167 168 169 170 171 172 173 174 ... 179 180

Sin comentarios

Cooper Security i-on160EX Guía de instalación Pagina 169