
Step by Step Programming Procedures i-on160
Page 118
10. Fit suitable batteries to the radio keypad.
When you fit the final battery the radio keypad
transmits its identity to the control unit. When
the control unit learns the identity it displays the
radio keypad’s signal strength.
ADD/DEL RADIO KPD
Keypad added SS: 9
11. Press Y.
The bottom line of the display shows the
keypad’s default name. The “*” at the left of the
display shows that the control unit has learned
the radio keypad’s identity.
ADD/DEL RADIO KPD
*Radio Kpd 01 >
12. Carry on with any other programming you need
to do.
Deleting a Radio Keypad
To remove a Radio Keypad from the system:
1. Enter Installer Menu.
INSTALLER MENU
Detectors/Devices >
2. Press Y.
DETECTOR DEVICES
Detectors >
3. Press n until the display shows:
DETECTOR DEVICES
Radio Keypads >
4. Press Y.
RADIO KEYPADS
Add/Del Radio Kpd >
5. Press Y.
The bottom line of the display shows the first of
the available radio expanders.
ADD/DEL RADIO KPD
Exp. R1-02 (R30)>
6. Press u or n to select the expander that the
radio keypad is allocated to.
Note: This example assumes that your radio
expanders are bus devices 02 and 05. The
numbers may be different on the system you
are working on.
ADD/DEL RADIO KPD
Exp. R1-05 (R10)>
7. Press Y.
The bottom line of the display shows the first of
the device addresses used for radio keypads on
that expander. (See page 18 for an explanation
of radio keypad numbering.) If a radio keypad is
already learned into the system at that address
then the bottom line of the display shows a “*”
on the left and displays the radio keypad’s name.
ADD/DEL RADIO KPD
*Radio Kpd 01 >
8. Press u or n to select the keypad that you wish
delete.
ADD/DEL RADIO KPD
*Radio Kpd 02 >
Comentarios a estos manuales