Cooper Security i-on160EX Guía de instalación descargar pdf (Pagina 153)

i-on160 Step by Step Programming Procedures

Page 147

8. Trigger the alarm and tamper of each zone.

As you trigger the zones the top line of the

display shows the number of zones remaining

to be tested. The bottom line of the display

shows the first in a list of the zones that you

have selected for testing.

Each zone that you test shows an “A” if you

have tested the Alarm contacts and a “T” if you

have tested the tamper.

The chime tone will sound for each zone you

activate if you have enabled Chime.

Press if you wish to see a list of the zones

not yet triggered.

23 Zone(s) to test

Zone 020 TA

9. Press u or n to scroll up or down the list of

zones.

Press X to finish the test.

Testing a Remote Control:

1. Enter the installer menu and select Test (see

steps 1 to 4 in “To start testing” on page 144).

TEST

Sirens & Sounders >

2. Press n until the display shows:

TEST

Remotes >

3. Press Y.

The display instructs you to press any button on

the remote.

If the display shows “No Remotes Learnt” then

there are no remotes learned into the system.

Press required

Remote button

4. Press one button on the remote.

RM01, B4: User 02

Unset All SS9

The example display at right shows:

“RM01”= The name of the remote.

“B4” = The button you pressed.

“User 02” = The user who the remote is assigned to.

“Unset All” = The function of the button.

“SS9” = The radio signal strength of the remote.

5. Press any other buttons on the remote that you

wish to test.

RM01, B3: User 02

Toggle op1l SS9

6. Press X to finish the test.

TEST

Remotes >

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 179 180

Comentarios a estos manuales

Sin comentarios

Cooper Security i-on160EX Guía de instalación Pagina 153

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper Security i-on160EX