Cooper Security i-on160EX Guía de instalación descargar pdf (Pagina 170)

Appendix III i-on160

Page 164

1. Enter programming mode as follows:

a) Open the tamper switch.

The Red Trouble LED glows.

b). Press SELECT.

The blue LED 1 glows.

2. Press SELECT.

The blue LED 2 glows.

3. Press SET.

The WAM is in menu 2 – Delete Detectors.

If any blue LEDs flash then those channels are in

use.

4. If necessary, press SELECT to select the detector

you wish to delete. The blue LED of the selected

detector flashes.

5. Press and hold ESC for at least four seconds.

The WAM sounder gives a double beep to confirm

that the WAM has deleted the transmitter from

that channel. The blue LEDs show menu 2.

6. Repeat steps 3 to 5 for the other detectors as

necessary.

7. Leave programming mode as follows:

a) Leave menu 2 by pressing ESC. The sounder gives

a regular beeping tone to remind you to replace

the lid.

b) Close the lid tamper.

After a few seconds the WAM bleeps twice and the

red Trouble LED goes dark.

NOTE: You must leave programming mode in order to

save the changes you have made.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 179 180

Sin comentarios

Cooper Security i-on160EX Guía de instalación Pagina 170