
Step by Step Programming Procedures i-on160
Page 116
Assigning a Wired keypad to Partitions
Note: If you selected “Part set mode” during Initial Power-up then you cannot
assign a keypad to a partition (see System Options–Restore Defaults–Factory
Defaults on page 67 if you want to change the system from Part Setting to
Partitions).
1. Enter Installer Menu.
INSTALLER MENU
Detectors/Devices >
2. Press Y.
DETECTOR DEVICES
Detectors >
3. Press n until the display shows:
DETECTOR DEVICES
Wired Keypads >
4. Press Y.
The bottom line of the display shows:
WIRED KEYPADS
Address Bus Device>
5. Press n until the display shows:
WIRED KEYPADS
Edit Keypad >
6. Press Y.
The bottom line of the display shows the first in
a list of the available wired keypads.
EDIT WIRED KEYPADS
Keypad K1-51 >
7. Press u or n to select the keypad that you wish
to assign. Then press Y.
The bottom line of the display shows:
Keypad K1-53
Name >
8 Press n until the display shows:
Keypad K1-53
Partitions >
9. Press Y.
The bottom line of the display shows the first
item in the list of partitions.
Keypad K1-53
Partition 01 Yes
10. To allocate a keypad to a partition press > or <
until the end of the bottom line shows “Yes”.
To remove a keypad from a partitions press > or
< until the end of the bottom line shows “No”.
You can allocate a keypad to more than one
Partition: press u or n to see the other
partitions. See page 52 for more information
about partitions.
Keypad K1-53
Partition 01 No
If you want to allocate a keypad to all partitions
at once:
Press u or n until the bottom line shows “All
Partitions”.
Press > or < until the end of the bottom line
shows “Yes” to allocate the keypad to all
partitions or “No” to remove the keypad from all
Keypad K1-53
All partitions Yes
Comentarios a estos manuales