Cooper Security i-on160EX Guía de instalación descargar pdf (Pagina 167)

i-on160 Appendix III

Page 161

3. Set the WAM to the Mode 1 (Repeater)

1. Apply power to the WAM.

2. Enter programming mode as follows:

a) Make sure the tamper switch has opened.

The Red Trouble LED glows.

b). Press SELECT.

The blue LED 1 glows. The WAM is in menu 1.

3. Use menu 7 to

o into mode selection as follows:

a) Press SELECT repeatedly until LED 7 glows.

b) Press SET.

The blue LEDs show the current mode. When

delivered from the factory the WAM is in mode 1

(LED 1 glowing).

4. If necessary, select mode 1 by pressing SELECT

repeatedly until LED 1 lights up.

(Note that LED 6 does not light up.)

5. Press SET.

The sounder gives a double “beep” and the LED

7 glows again. The WAM is now back in menu 7.

6. Leave programming mode as follows:

a) Press ESC/DEL.

The blue LED goes dark. The sounder gives a

regular beeping tone to remind you to replace

the lid.

b) Replace the lid (or operate the tamper switch).

After a few seconds the red Trouble LED switches

off and the sounder gives a double beep

confirmation tone.

NOTE: You must leave programming mode in order to

save the changes you have made.

Teach the Expander the Identity of the WAM

At The Control Unit:

1. Enter Installer Menu.

INSTALLER MENU

1 2 ... 162 163 164 165 166 167 168 169 170 171 172 ... 179 180

Sin comentarios

Cooper Security i-on160EX Guía de instalación Pagina 167