Cooper Security i-on160EX Guía de instalación descargar pdf (Pagina 50)

Installer Menu Options i-on160

Page 44

When delivered from the factory, or if you restore the control unit to factory

settings, then all radio sirens belong to partition 1.

Once you have entered the Partitions option, press u or n to scroll through

the list of partitions followed by > or < to allocate/deallocate the radio siren to

each partition as necessary.

If you wish to allocate/deallocate the radio siren to many partitions you can

use the “All Partitions” option (in between partition 1 and 20 on the menu) to

either allocate or deallocate the radio siren to all partitions in one operation.

Once you have carried out this operation you can then scroll through the

partition list and change the allocation of the radio siren as necessary.

WAMs

The i-on160EX can operate up to 20 770r WAM modules. Although the WAM

provides five different modes, when working with an i-on160EX only mode 1,

repeater module, is relevant. The installer must select the repeater mode when

commissioning the WAM hardware.

When working as a repeater module the WAM repeats the signals from any

detectors within its range, amplifying them to a level that the i-on160EX

control unit can detect. This allows you to increase the area covered by

detectors.

Naming WAMs

Use the Edit WAM option to give each WAM a meaningful name. The name can

be up to 12 characters long.

Outputs

The i-on160EX control unit provides three different sets of outputs:

Dedicated Bell and Strobe outputs.

4 hardwired outputs.

16 plug-by outputs.

(See i-on160EX Installation Guide for the position of connectors.)

In addition to the outputs wired directly into the control unit, expanders also

provide outputs:

Each wired expander provides 4 outputs on its pcb.

Radio expanders each provide 10 radio output channels.

All these sets of outputs, both on the control unit and on expanders, can be

programmed as any of the output types listed on page 45.

The software within an i-on160EX control unit can handle up to 164 outputs in

total. If the number of physical outputs attached to the system exceeds this

maximum then the installer menu will not let you program some of those

outputs.

Bell and Strobe

You can program the behaviour of the dedicated Bell and Strobe outputs on

the control unit pcb with the following options:

Name You can assign a 12 character name to the Bell and Strobe

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 179 180

Comentarios a estos manuales

Sin comentarios

Cooper Security i-on160EX Guía de instalación Pagina 50

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper Security i-on160EX