Cooper Security i-on160EX Guía de instalación descargar pdf (Pagina 43)

i-on160 Installer Menu Options

Page 37

Chime

When enabled by the user, the system gives a non-alarm warning tone

when any zones programmed as ‘Chime’ are opened. This facility operates

only while the system is unset.

Soak Test

Use this zone attribute if you want to place under long term test a

detector that you suspect is giving false alarms. Zones with this attribute

are disabled for 14 days after you return the control unit to user/unset

mode. If the zone remains inactive for the whole fourteen days then after

midnight on the 14th day the control unit returns the zone to normal use.

If the zone is activated during those 14 days while the system is set then

the control unit logs the event as a “Soak Test Fail Z1-ee-nn” (ee is the

bus device number and nn is the zone number, see page 17) without

sounding any sirens or starting communications. The control unit also

lights the red LEDs around the navigation key on the keypad to alert the

user. An installer must key in their access code to reset the alert.

You can apply the soak test attribute to Normal Alarm, Entry Route and

Tamper zone types.

During setting the keypad displays a brief message to inform the user that

one or more zones are in soak test.

Double Knock

Zones programmed with this attribute will cause an alarm only if the zone

is EITHER triggered, restored and triggered again within a five minute

period, OR if the zone remains active for 10 seconds.

You can apply the Double Knock attribute to the Normal Alarm and Entry

Route zone types.

Part Set B

(Not visible in a partitioned system.) When a user presses button B (part

set), the control unit sets only those zones where the Part Set B attribute

= “Yes”. (See also “Part Set Exit Mode” on page 54 ).

Part Set C

(Not visible in a partitioned system.) When a user presses button C the

control unit sets only those zones where Part Set C attribute = “Yes”.

Part Set D

(Not visible in a partitioned system.) When a user presses button D the

control unit sets only those zones where Part Set D attribute = “Yes”.

Part Set

(Not visible in a Part Setting system.) When a partition is Part Set, zones

in that partition with this attribute are set. Note that if a zone is in more

than one partition, all partitions have to be set or part set before this zone

will be set.

Omittable

This attribute applies to the following zone types only: Normal Alarm,

24hr, Technical, Entry Route, Tamper, External PSU A/C Fail, External PSU

Battery Fault, External PSU Low Volts and External PSU Fault.

A) When a zone has this attribute, a user can omit it before

setting the

system.

B) If a user tries to set the system when a zone with this attribute is open

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 179 180

Comentarios a estos manuales

Sin comentarios

Cooper Security i-on160EX Guía de instalación Pagina 43

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper Security i-on160EX