Cooper Security i-on160EX Guía de instalación Pagina 101

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 180
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 100
i-on160 Installer Menu Options
Page 95
During the test call the keypad display will show a sequence of progress
messages, for example:
Dialling...
Connected...
Negotiating...
Call Successful... (or Call Failed...).
If the call fails the keypad display will show a brief message giving the reason
for failure.
Speech Dialler
The Test menu allows you to send a test speech call to any telephone number
(not just the ones programmed to receive speech messages in the event of an
alarm).
From the Installer Menu select Test – Speech Dialler.
The keypad display shows a message asking you to key in a telephone
number.
Key in the telephone number of the phone that you wish to receive the test
message and press Y.
When you press Y the control unit starts the test call. The keypad display
shows: “Dialling...”.
When the person at the receiving end answers the call the display shows
“Connected...”.
The control unit will play the home message followed by each of the four alarm
messages, and then repeat all five messages three more times. While the
control unit is playing the messages the keypad display shows “Playing
messages...”.
The person receiving the messages call acknowledge (and end) the call by
pressing “5” of “9” on their phone keypad.
If no-one acknowledges a test call the keypad display shows “No
acknowledgement”.
PSU Current
The Test menu allows you to check how much current the control unit is
consuming. From the Installer menu select Test – PSU Current. The bottom line
of the keypad display shows the current delivered by the PSU in the control
unit.
Locate Bus Device
The Test menu allows you to list all the devices connected to the bus, and to
find out where they are located by activating their sounder. From the Installer
menu select Test – Locate Bus Device.
The control unit presents the first item in a list of all the devices connected to
the bus. The keypad display shows the expander bus number, and any name
that has been programmed for it.
Vista de pagina 100
1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 179 180

Comentarios a estos manuales

Sin comentarios