Cooper Security i-on160EX Guía de instalación descargar pdf (Pagina 111)

i-on160 Step by Step Programming Procedures

Page 105

with an alert. When a user reads the alert it will

show the address of the disabled expander.

To enable the expander again, repeat steps 1 to

11, but at step 8 press > or < until the end of

the bottom line shows “Yes”.

To Replace an Expander:

1. Enter Installer Menu.

INSTALLER MENU

Detectors/Devices >

2. Press Y.

The display shows:

DETECTORS/DEVICES

Detectors >

3. Press n until the display shows:

EITHER (if you are replacing a wired expander):

OR (if you are replacing a radio expander):

DETECTORS/DEVICES

Wired Expanders >

DETECTORS/DEVICES

Radio Expanders >

(The rest of these instructions assume you are

replacing a wired expander. The instructions are

similar but the displays are slightly different for

a radio expander.)

4. Press Y .

The display shows:

WIRED EXPANDERS

Address Bus Device >

5. Press n until the display shows:

WIRED EXPANDERS

Replace Expander

6. Press Y .

The display shows the first in a list of the

expanders that are currently connected to the

bus.

REPLACE EXPANDER

Exp. W1-01 Remove

7. Press u or n until the display shows the

expander you wish to replace (in this example,

expander W1-04):

REPLACE EXPANDER

Exp. W1-04 Remove

8. Press Y .

The display shows:

Notes:

1. If you change your mind and do NOT wish to

replace the expander then press

Exp. W1-04

Remove Expander?

9. Press Y .

The display shows for a few seconds:

W1-04 can be removed

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 179 180

Comentarios a estos manuales

Sin comentarios

Cooper Security i-on160EX Guía de instalación Pagina 111

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper Security i-on160EX