Cooper Security i-on160EX Guía de instalación Pagina 110

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 180
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 109
Step by Step Programming Procedures i-on160
Page 104
(The rest of these instructions assume you are
disabling a wired expander. The instructions are
similar but the displays are slightly different for
a radio expander.)
4. Press Y .
The display shows:
WIRED EXPANDERS
Address Bus Device >
5. Press n until the display shows:
WIRED EXPANDERS
Enable Expander
6. Press Y .
The display shows the first in a list of the
expanders that are currently connected to the bus.
ENABLE EXPANDER
Exp. W1-02 Yes
7. Press u or n until the display shows the
expander you wish to enable or disable (in this
example, expander W1-04):
The right hand end of the bottom line shows the
state of the expander: “Yes” for enable, “No” for
disable.
ENABLE EXPANDER
Exp. W1-04 Yes
8. Press > or < until the end of the bottom line
shows the state you want.
This example shows the expander being
disabled:
Notes:
1. If you change your mind and do NOT wish to
disable the device shown then press
>
or
<
until the bottom line shows “Yes”.
ENABLE EXPANDER
Exp. W1-04 No
9. Press Y .
The display shows the Enable Expander option.
The control unit disables the expander you
selected in step 7. If you wish to enable the
expander follow steps 6 to 8 again, but ensure
that the bottom line of the display shows “Yes”
for the selected expander.
WIRED EXPANDERS
Enable Expander >
10. Press X until the display shows:
Leave
installer mode?
11. Press Y.
The display shows:
Please wait...
After a short time (depending on the number of
bus devices fitted to the system) the display
shows the time and date, for example:
i-on160EX
12:43 02/11/2010
The keypad navigation key LEDs will glow red
Vista de pagina 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 179 180

Comentarios a estos manuales

Sin comentarios