Cooper Security 9751 Manual de instalación descargar pdf (Pagina 99)

4. Programming

496964 Page 91

24 Strobe Set C: active for 10 seconds after Partition C is set.

25 Strobe Set D: active for 10 seconds after Partition D is set.

26 Pulse Set 1: active for time set by Command 170.

27 Pulse Set 2: active for time set by Command 170.

28 Pulse Set 3: active for time set by Command 170.

29 Pulse Set 4: active for time set by Command 170.

30 Pulse Unset 1: active for time set by Command 172.

31 Pulse Unset 2: active for time set by Command 172.

32 Pulse Unset 3: active for time set by Command 172.

33 Pulse Unset 4: active for time set by Command 172.

34 Fire: active during a Fire alarm.

35 PA: active during a PA.

85: Burglar Communications Rearm

This Command determines what happens to the "Burg" communications

output (or channel) at the end of the bell run time.

Option

0 Latched. The output stays active until an engineer or user resets the

system.

1 Rearm. The system turns off the "burg" channel when the bell run time

has expired. Once the channel is inactive, the system is ready to

report any new alarm.

Note: If Alarm Abort is enabled (Command 36, option 1), the "burg" channel

restores if the user unsets the system.

86: Dual Ply Entry Warning

Note: Disable Alarm Confirmation (Command 89) to use this Command.

If users habitually exceed the Entry Time, select option 1 to add a 30-second

extension during which the internal sounders give a warning tone. Select

option 0 (the default value) to disable Dual Ply Entry.

The extension applies to both full and part setting.

Note: Using Dual Ply Entry is not recommended because it does not comply

with industry standards for alarm system operation.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 147 148

Sin comentarios

Cooper Security 9751 Manual de instalación Pagina 99