Cooper Security 9751 Manual de instalación descargar pdf (Pagina 87)

4. Programming

496964 Page 79

51: Set Time and Date

The system has an internal clock/calendar, which it uses to date stamp the log

print-out. To set the system's clock/calendar to the correct time and date:

1. Enter programming mode (if you are not already there).

2. Key in 51Y at the keypad.

The display shows the current date, for example:

D11 M09 Y01

3. Key in two digits for the day (01–31) and press Y. Use a leading zero for

the first nine days of the month.

4. Key in the two digits for the month (01–12) and press Y . Use a leading

zero for January to September.

5. Key in the last two digits of the year (00–99) and press Y.

The display shows the current time, for example:

H09 M15

6. Key in two digits for the hour of the day (00–23) and press Y. Use the

24-hour clock.

7. Key in two digits for the minutes (00–59) and press Y.

The keypad sounder gives a double "beep" and the display shows

Installer Mode". The system sets its internal clock/calendar to the date and

time that you gave.

52: Omit Alarm

This Command specifies whether, when a user omits a zone, the control unit

omits the tamper contacts as well as the alarm contacts.

Option

0 The control unit omits alarm contacts only

1 The control unit omits both alarm and tamper contacts.

Note: To permit the user to omit a zone, you must set attribute

4 for the

zone.

53: Abort Reset

This Command specifies how the system is reset after an aborted alarm.

Option

0 Use the reset option selected for the system with Command 33

(default).

1 Permit the user to reset after an abort.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 147 148

Sin comentarios

Cooper Security 9751 Manual de instalación Pagina 87