Cooper Security 9751 Manual de instalación descargar pdf (Pagina 112)

4. Programming

Page 104 496964

129: Telecommand Requires Entry for Unset

If the system is fitted with a radio expander, the user can use a telecommand

(remote setting device) to set and unset the system. This Command provides

two options for unsetting the system with a telecommand:

Option

0 The user must first trigger the entry zone and start the entry timer

before unsetting the system with a telecommand.

1 The user can unset the system using a telecommand without first

starting the entry timer by triggering the entry zone.

In the UK, to conform with Class VI radio requirements, set Command 129 to

option 0 and select Final Door Set with the appropriate command for the level

or partition (Command 39, 62, 72 or 76). This prevents users from unsetting

the system from outside the building.

130: Not used

This command is not used.

131: SIA Report Mode

SIA reports are called "Telegrams". Each telegram contains the site

identification number (normally six digits) and relevant event information. The

amount of information reported depends on the SIA mode that you select:

Basic, Summary, Intermediate or Full. The following table shows the types of

report for each mode; use this to decide which mode is appropriate for the

installation. Each mode also contains all the reports in the mode above it.

Option

0 Basic

1 Summary

2 Intermediate

3 Full

The system also provides a "custom" mode, which allows any combination of

event information, but you have to use Downloader to create the required

combination.

Note: The control unit delays reporting/logging either mains loss, or exiting

engineering with mains loss, by 15-18 min (chosen at random). The

control unit delays reporting/logging either mains restore, or exiting

engineering with mains restored, by 60-90 sec (chosen at random). If

you select a Scandinavian default in Command 0, the control unit waits

at least 60 minutes before reporting.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 147 148

Sin comentarios

Cooper Security 9751 Manual de instalación Pagina 112