Cooper Security 9751 Manual de instalación descargar pdf (Pagina 126)

4. Programming

Page 118 496964

Using a Partitioned System

Introduction

When programming a control unit, there are two ways of changing from a

single system to a partitioned system:

a) during initial power up

b) using Command 98.

To create a partitioned system during initial power up, see page 45.

If you have an existing control unit that has already been programmed as a

single system and wish to convert it to a partitioned system, then:

1. Enter programming mode (if you are not already there).

2. Key in 98 Y at the keypad.

The display shows:

Load Default

3. Press 1 Y at the keypad.

The display shows (for example):

Mult Sys? OFF

4. Either:

Press 1 to create a partitioned system

Or press 0 to create a single system.

The display shows (for example):

Mult Sys? ON

5. Press Y.

The keypad gives a double "beep" confirmation tone and the control unit

loads the factory default values, erasing all previously programmed

values.

Note: The log is protected and cannot be erased by the Installer.

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 147 148

Sin comentarios

Cooper Security 9751 Manual de instalación Pagina 126