Cooper Security 9751 Manual de instalación descargar pdf (Pagina 104)

4. Programming

Page 96 496964

To make static test call at regular intervals, you have two options:

Cnn To make a static test call every nn hours, press C and then key in a

number between 01 and 24 to select the interval in hours. For example,

key in 12 to program the control unit to make a call every 12 hours.

Dnn To make a static test call every nn days, press D and then key in a

number between 01 and 28 to select the interval in days. For example,

key in 07 to program the control unit to make a call every 7 days.

The control unit adjusts the timing of calls by up to 16 minutes (exact interval

chosen at random) to ensure that the ARC is not overwhelmed by a flood of

test calls from systems that have all been set with the static test options.

Note: Cooper Security recommends that you choose either Static Test Call

(105) or Dynamic Test Call (108), but not both at the same time.

106: Line Fault Response

This Command sets how the control unit responds when it detects a fault on

an attached telephone line. Its exact response depends on whether the

system is set or unset:

Option

0 Disabled. The control unit does not monitor the telephone line.

1 Audible.

If the system is unset, the control unit logs the event and the keypads

emit a short audible tone every minute. Entering a valid access code

silences the sounders and the keypad displays indicate a telephone

line fault. The system can be set again with the line fault present.

If the system is set, the control unit logs the event but the keypads do

not emit a tone or display a message. If the line is out of order when

an alarm occurs, the control unit cancels any programmed Bell Delay.

Note: Audible response is the NACOSS recommendation for line faults.

2 Silent.

If the system is unset, the control unit logs the event and the keypad

displays indicate a telephone line fault (without giving any audible

warning). The system may be set again with the line fault present.

If the system is set, the control unit logs the event but the keypads do

not display a message. If the line is out of order when an alarm

occurs, the control unit cancels any programmed Bell Delay.

107: Not used

This command is not used.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 147 148

Sin comentarios

Cooper Security 9751 Manual de instalación Pagina 104