Cooper Security 9751 Manual de instalación descargar pdf (Pagina 32)

3. Installation

Page 24 496964

6. Mount the front cover of the keypad (containing the keypad PCB) onto

the backplate and make sure that the tamper switch operates.

7. If the tamper switch does not operate, rotate the cam until the switch

operates correctly with the front of the keypad mounted on the backplate.

1. Fixing hole 3. Adjustable cam

2. Cable entry 4. Remove these cable clips when fitting a 934 module

Figure 10. Backplate of the 9930 Keypad

Fitting the ScanProx 934 Module

Note: If fitting a 934 module to an existing installation, put the alarm system

into programming mode and then remove all power, both mains and

battery. If you do not remove all power, the system will not recognise the

934 module.

1. Remove the front cover from the keypad(s) to which you intend to fit the

module. Remove the cable clips (item 4 in Figure 10).

2. Fit the 934 module to the connector pins, as shown in Figures 11 and 12.

Figure 11. Fitting a 934 Module (over the keypad)

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 147 148

Sin comentarios

Cooper Security 9751 Manual de instalación Pagina 32