Cooper Security 9751 Manual de instalación descargar pdf (Pagina 123)

4. Programming

496964 Page 115

191 to 198: Fast Format Channels

If Fast Format reporting is selected (Command 103, option 0) Commands 191

to 198 allow you to assign one of the following events to each output.

Command 191 controls output 1, 192 output 2, and so on up to Command

198 which controls output 8. Each Command has the same options:

00 Not Used 19 Smoke Detector

01 Fire 20 Comms Acknowledge (see Note)

02 PA 21 Battery Fault

03 Burglary 22 System Alarm

04 Open/Close 23 Alarm Partition 1

05 Alarm Abort 24 Alarm Partition 2

06 Technical Alarm 25 Alarm Partition 3

07 Alarm Confirmation 26 Alarm Partition 4

08 RF Low Battery 27 Not used

09 Supervision Loss 28 Not used

10 RF Jamming 29 Not used

11 AC Fail 30 Set OP 1

12 Tamper Alarm (day tamper) 31 Set OP 2

13 Open 32 Set OP 3

14 Close 33 Set OP 4

15 Zone Omitted 34 Unset OP 1

16 Medical Assistance 35 Unset OP 2

17 Key Box 36 Unset OP 3

18 Anti-Mask 37 Unset OP 4

Notes:

1. 13 Open and 14 Close provide the same functions as 4 Open/Close,

but on two separate channels.

2. 15 Zone Omitted – the control unit sends this signal for five seconds

when a user omits a zone.

3. The control unit sends 08 RF Low Battery when the radio detector with

a low battery causes an alarm or sends a supervision signal. To enable

this facility in day mode set Menu 37 to option 1.

4. The control unit delays reporting/logging either mains loss, or exiting

engineering with mains loss, by 15-18 min (chosen at random). If you

select a Scandinavian country in Command 0, the control unit waits at

least 60 minutes before reporting.

199: Display Zone Circuit Resistance

For information on this command, see "5.Testing".

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 147 148

Sin comentarios

Cooper Security 9751 Manual de instalación Pagina 123