Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 85)

i-on40 Installer Mode Programming

Page 81

Once Downloader is connected to the control unit then it

has access to all system programming. If you wish to

provide secure access then use either Call Out Only or

Secure Callback. Please note that you cannot use Secure

Callback with Local connection.

Call Out Only.

Someone must start a call to the remote PC manually

from within User Menu (select User Menu – System

Config – Call to Dwnldr).

Secure Callback.

When the remote PC calls, the system waits for the

set number of rings (see "Rings to Answer") and then

answers. The remote PC sends a control unit ID, the

Downloader software version, and indicates which of

the two Downloader Telephone Numbers to use (see

“Phone Book” below). The system checks that the

remote PC is sending the correct control unit ID, and

is using the correct Downloader software version. If

these items don't match then the system hangs up. If

the items do match then the system hangs up and,

after a short delay, the system seizes the telephone

line and calls the PC using the indicated Downloader

Telephone Number.

Notes:

a) Secure Call Back must be Disabled until the first

“attended” upload has been performed. This first

upload can be carried out either from User Menu, or

from Installer Menu.

b) Secure Call Back mode does not comply with

EN50131.

Unattended.

The control unit answers as soon as the number of

rings set in "Rings to Answer" or "Answer on One

Ring" have elapsed.

Notes:

a) The Downloader operator can choose to use

Secure Callback, even though the alarm system is

programmed for Unattended Mode.

b) Unattended mode does not comply with EN50131.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 115 116

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 85