Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 22)

Installer Mode Programming i-on40

Page 18

them and pauses the setting procedure. The user can

acknowledge the alert by pressing Y and continue

setting. You must enable this feature in the System

Options – User Access – Quick Omit menu, see page 50.

Force Set Omit

When this attribute is set to Yes a user with a remote

control can set the system while the zone is open

(active). (You must enable this feature in the System

Options – Force Set menu. See page 57.)

Wired Keypads

The i-on40 allows you to give each wired keypad a name,

and assign a keypad to one or more partitions.

The control unit displays the name you give to the

keypad when it is reporting faults or other events,

making it easier to locate the affected device.

Naming a Wired Keypad

To name a wired keypad:

1. Select Detectors/Devices – Wired Keypads.

The bottom line of the display shows the first in a list

of the wired keypads. If a keypad is connected to the

system then the bottom line of the display shows a

“*” at the beginning of the line.

2. Press u or n to select the keypad that you wish to

name. Then press >.

The bottom line of the display shows “Name”.

3. Press >.

The top line of the display shows the selected keypad

and the bottom line shows the current name of the

keypad with a text entry cursor at the beginning of

the line.

4. Key in the name of the wired keypad.

See page 7 for hints on how to edit names.

5. Press Y to save the text.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 115 116

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 22