Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 82)

Installer Mode Programming i-on40

Page 78

control unit by selecting the About Panel - About Comms

- IP Address option from the Installer menu. See page

91.

If there is a GPRS or Ethernet module fitted then the

above items appear under a sub-menu titled “Panel

Ethernet”.

If you have fitted a GPRS module you will also see the

menu option “Module: GPRS”. This menu has the

following options:

IP Address

This is the module’s own IP address. If you leave it

blank the service provider will give the module an IP

address using DHCP. (Cooper Security recommend

that you leave this field blank.)

Port Number

If you wish to change the port number used by the

module then key in the new port number here.

APN

Key in the GPRS Access Point Name here.

Username

Use this option to store the GPRS User ID.

Password

Use this option to store the GPRS password.

If you have fitted an Ethernet module you will see the

menu option “Module: Ethernet”. This menu has the

following options:

IP Address

This is the module’s own IP address.

Sub-Net Mask

If necessary, key in the sub-net mask, for example

“255.255.255.000”.

Note: If you leave IP Address and Sub-Net Mask blank

then the control unit will use DHCP (Dynamic Host

Control Protocol) to obtain these values from a DHCP

server.

Gateway Address

This is the IP address of the router that connects the

local network, to which the i-on40 is connected, to

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 115 116

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 82