Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 33)

i-on40 Installer Mode Programming

Page 29

Deleting a WAM

To remove a WAM from service in the system, then:

1. Select Detectors/Devices – WAM – Add/Del WAM.

The bottom line of the display shows the first in a list

of the available WAMs.

2. Press u or n to select the WAM you wish to delete

then press Y. (When a slot is occupied with a WAM

then the bottom line shows a “*” at the beginning.)

The display asks you to confirm your choice.

3. Press Y.

The control unit deletes the WAM’s identity from the

selected memory slot.

Outputs

The i-on40 control unit provides three different sets of

outputs:

8 radio outputs. To use these outputs you must install

a radio receiver, for example a WAM, 762 or 768.

4 hardwired outputs.

12 plug-by outputs.

(See i-on40 Installation Guide for the position of

connectors.)

All three sets of outputs can be programmed as any of

the output types listed on page 34.

Radio Outputs

To use a radio output on a WAM see page 27 .

To use a radio output on a 762r, 768r or 769r receiver

you must teach the identity of the i-on40 control unit to

the receiver.

Note: If you are teaching 762r, 768r, or 769r receivers

then make sure that you disable IR learn on the

receivers first.

Adding Radio Outputs

To teach the control unit's identity to a 762r, 768r or

769r:

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 115 116

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 33