Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 8)

Entering and Leaving Installer Menu i-on40

Page 4

appears on the bottom line.

Press u or n to display the other

sub-options.

Note: 1. After you initially gain access to the Installer

Menu, you may leave and re-enter using the Installer

access code by itself for up to 30 minutes after you

last exited the Installer Menu. After that time you will

need to enter a valid user access code to complete

your entry into the Installer Menu (note that you

cannot use a Set Only user code). To disable this

feature see System Options – User Access – User Code

Required on page 50.

2. If you key in the code incorrectly, the display

shows four “stars”. Key in the code again. If you key

in a total of ten incorrect codes (equivalent to 13

consecutive digits) then the system locks you out for

90 seconds.

Leaving the Installer Menu

If you wish to leave the Installer Menu at any time.

1. Press

X until the display shows:.

Leave

installer mode ?

2. Replace the control unit lid (if

you removed it earlier). Ensure

the control unit tamper switch is

closed.

3. Press

Y. to leave Installer

menu.

(Press X if you do not want

to leave the menu.)

The display shows the time and

date. The system is ready for

use.

i-on40

12:00 02/01/2008

Note: If you attempt to leave the Installer Menu when

there is fault, for example a detector–, control unit

lid–, siren– or keypad tamper is active, or the battery

is missing then the keypad displays a fault message

telling you which device is causing the problem.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 115 116

Comentarios a estos manuales

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Cooper Security i-on40