Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 51)

i-on40 Installer Mode Programming

Page 47

activate any output programmed as Strobe, plus the

strobe on any 760ES wireless siren. The

outputs/strobes are active for three seconds after the

system unsets. Strobe On Unset applies to Full Set

and all the Part Sets.

Alarm Response

You can select one of the following:

Internal: Keypads and loudspeakers

Siren Keypads, loudspeakers and siren

Siren + Comms Keypads, loudspeakers, siren and

communication.

Part Set Final Exit As

This option controls how the system will treat Final

Exit zones in a part set.

Final Door In a Part Setting system, any Final Exit

zones with the Part Set B, C or D

attributes will continue to act as Final

Exit zones during part set.

In a Partitioned system, any Final Exit

zones, belonging to the partition, with

the Part Set attribute will continue to

act as Final Exit zones during part set.

Normal

Alarm

In a Part Setting System any Final Exit

zones with the Part Set B, C or D

attributes will act as Normal Alarm

zones during part set.

In a Partitioned system, any Final Exit

zones, belonging to the partition, with

the Part Set attribute will act as

Normal Alarm zones during part set.

Part Set Entry Route As

This option controls how the system treats Entry

Route zones during part set.

Entry Route In a Part Setting system, all Entry Route

zones with the Part Set B, C or D

attributes will continue to act as Entry

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 115 116

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 51