Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 23)

i-on40 Installer Mode Programming

Page 19

Assigning keypads to Partitions

The i-on40 allows you to assign keypads to any of the

partitions.

Once you have assigned a keypad to a partition then that

keypad will display messages and give tones for the

assigned partition(s).

However, any user can use any keypad. While they are

using a keypad the display shows information from

partitions assigned to the user, not to the keypad.

To assign a keypad to a partition:

1. Select Detectors/Devices – Wired Keypad.

The bottom line of the display shows the first in a list

of the wired keypads. If a keypad is connected to the

system then the bottom line of the display shows a

“*” at the beginning of the line.

2. Press u or n to select the keypad you wish to assign

to a partition, then press >.

The bottom line shows “Name”.

3. Press n until the bottom line of the display shows

“Partitions”, then press >.

The bottom line shows the first partition. At the end

of the bottom line the display shows “Yes” if the

keypad is assigned to the partition, “No” if it is not

assigned to the partition.

4. Press < or > to toggle the “Yes” to a “No” or the

“No” to a “Yes”.

5. Press u or n to scroll to the next partition.

6. Press Y to save your changes when you have

finished.

Programming Quick Set Keys

Note: If you enable the quick set keys the control unit no

longer complies with EN50131. See page 49.

In a partitioned system the installer can program the A,

B, C and D keys to full set or part set individual

partitions. Each keypad can have a different arrangement

of quick set keys. For example the A key on keypad 1

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 115 116

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 23