Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 56)

Installer Mode Programming i-on40

Page 52

Entry Keypad Lock

This option determines whether the user can unset

the system by entering an access code after opening

the entry door.

Off: The user can enter an access code at the keypad

after the entry door opens (used for DD243:2004

clause 6.4.4).

On: The user must unset the system by some means

other than the keypad, for example prox tag or

remote control (used for DD243:2004 clause 6.4.5).

Note: This option functions when confirmation is ON and

communications is enabled. If communications is

disabled this option has no effect.

Sounder on

Unconfirm: When the system is set the control unit

activates the internal sounders when an unconfirmed

alarm occurs.

Confirm: When the system is set the control unit

does not activate the internal sounders until a

confirmed alarm occurs.

Siren on

Unconfirm: the control unit operates the siren for all

alarms (and overrides any Siren Delay).

Confirm: When the system is set the control unit

does not activate the siren(s) until a confirmed alarm

occurs.

Unconfirmed Reset

If you enable alarm confirmation then this option

overrides System Options - User Reset – Zone Alarms (see

page 50). You may then use the options below:

User: The user can reset after an unconfirmed alarm.

Installer: The user cannot reset after an

unconfirmed alarm, the installer must do it.

Note: If a user causes an alarm which would require

Installer reset then they have 90s to abort the alarm,

which they can then reset themselves.

Confirmed Reset

If you enable alarm confirmation then this option

overrides System Options - User Reset – Zone Alarms (see

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 115 116

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 56