Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 21)

i-on40 Installer Mode Programming

Page 17

Alarm, Entry Route and Tamper zone types.

During setting the keypad displays a brief message to

inform the user that one or more zones are in soak

test.

Double Knock

Zones programmed with this attribute will cause an

alarm only if the zone is EITHER triggered, restored

and triggered again within a five minute period, OR if

the zone remains active for 10 seconds.

You can apply the Double Knock attribute to the

Normal Alarm and Entry Route zone types.

Part Set B

(Not visible in a partitioned system.) When a user

presses button B (part set), the control unit sets only

those zones where the Part Set B attribute = “Yes”.

(See also “Part Set Exit Mode” on page 45 ).

Part Set C

(Not visible in a partitioned system.) When a user

presses button C the control unit sets only those

zones where Part Set C attribute = “Yes”.

Part Set D

(Not visible in a partitioned system.) When a user

presses button D the control unit sets only those

zones where Part Set D attribute = “Yes”.

Part Set

(Not visible in a Part Setting system.) When a

partition is Part Set, zones in that partition with this

attribute are set. Note that if a zone is in more than

one partition, all partitions have to be set or part set

before this zone will be set.

Omittable

This attribute applies to the following zone types

only: Normal Alarm, 24hr, Technical, Entry Route,

Tamper, External PSU A/C Fail, External PSU Battery

Fault, External PSU Low Volts and External PSU Fault.

A) When a zone has this attribute, a user can omit it

before

setting the system.

B) If a user tries to set the system when a zone with

this attribute is open (active) the control unit alerts

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 115 116

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 21