Cooper Security i-on40 Guía de instalación descargar pdf (Pagina 74)

Installer Mode Programming i-on40

Page 70

control unit (usually by pressing buttons on the telephone

key pad). The commands available are:

Function Key

End this call DTMF ‘5’

Play ‘Home’ and ‘alarm’ message DTMF ‘3’

Clear down DTMF ‘9’

Note that when the called party answers a speech dialler

call there could be a six second delay before the

control unit starts playing the home message.

Call Mode

This option enables or disables the speech dialler feature.

To employ speech dialling set the call mode to “Enabled”.

Messages

To record the speech messages you wish the speech

dialler to use enter Installer Menu and select

Communications – Speech Dialler – Messages.

There are five messages slots available: The Home

Message and Messages 1 to 4. Within each message you

can use one of the following options:

Record Message Press > to start recording. The control

unit starts recording from the i-sd02’s built in

microphone. The display shows a progress bar indicating

how long you have left to record. Press X to end

recording.

Play Message Press > to play back the message from

the i-sd02’s speaker.

Delete Message Press > to delete the message. When the

display asks “Delete Message?” press Y.

Use Lid Tamper This puts the control unit into a special

mode where the tamper switch controls the recording and

playback of the current message. Use this mode if the

control unit is an inconvenient distance from the keypad.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 115 116

Sin comentarios

Cooper Security i-on40 Guía de instalación Pagina 74