Cooper Security 9751 Guía de usuario descargar pdf (Pagina 70)

2. Programming Commands

Page 64 497096, issue 3

185: Keyswitch Auto Reset

This command instructs the control unit to reset automatically if the user uses

the keyswitch to set the system on leaving.

Option

0 Off (default). User must reset manually.

1 On. System resets automatically when the user sets it with a

keyswitch (KM or KF).

Note: Compliance with PD 6662 / prEN 50131-1: 2004 (see page 85) requires that

Command 185 is set to option 0.

186: Set Number of Home Beep Calls

This command sets the number of times that the control unit will call if

Reporting Type is set to Home "beep" (Command 103, option 6). The

repeated message acts as a confirmation.

Enter two digits, from 01 to 15 (default 02). The default is usually sufficient,

providing one call to alert the user and a second call to confirm the alert. For

the 9853 only, the user can acknowledge the call by pressing 5 on the

telephone handset; this terminates the series of home "beep" calls.

Note: This command sets the number of successful calls the system makes. It does not

include retries after failed communication attempts, which are built into the general

protocols used to control communications.

187 to 190: Not used

These commands are not used.

191 to 198: Fast Format Channels

If Fast Format reporting is selected (Command 103, option 0), Commands

191 to 198 enable you to assign types of events to outputs. The commands

take two digits to select the type (23-26 apply to a partitioned system only)

and have the following defaults:

Command Output Default type

191 1 01 Fire

192 2 02 PA

193 3 03 Burglar

194 4 04 Open/Close

195 5 15 Zone Omitted

196 6 05 Alarm Abort

197 7 07 Alarm Confirmation

198 8 06 Technical Alarm

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 95 96

Sin comentarios

Cooper Security 9751 Guía de usuario Pagina 70