Cooper Security 9751 Guía de usuario descargar pdf (Pagina 63)

2. Programming Commands

497096, issue 3 Page 57

143: Contact ID Report Restores

If the Reporting Type is set to Contact ID (Command 103, option 1), use this

command to select the types of contact ID messages that will be sent.

Option

0 Basic: all the messages with numbers in the "CID Code" column of the

table in "131: SIA Report Mode", except for those marked with an "‡".

1 Basic + Restore (default): all the messages with numbers in the "CID

Code" column of the table in "131: SIA Report Mode".

Note: If the keypad display shows "Custom" when you enter Command 143, Downloader

has been used to program Contact ID Report Restores.

144 to 150: Not used

These commands are not used.

151 to 158: Plug-by Communicator Outputs

These commands select types for the control unit's programmable outputs,

which can be used to control a plug-by communicator. All models provide

eight programmable outputs on the main circuit board and there is an optional

expansion for the 9853 that adds four more (see Commands 211 to 214 on

page 68). The outputs can be connected to the communicator by a wiring

harness provided with the control unit (refer to the 9x5x Installation Guide for

details). The commands take two digits to select the type (23-26 apply to a

partitioned system only) and have the following defaults:

Command Output Default type

151 1 01 Fire

152 2 02 PA

153 3 03 Burglar

154 4 04 Open/Close

155 5 15 Zone Omitted

156 6 05 Alarm Abort

157 7 07 Alarm Confirm

158 8 06 Technical Alarm

211 9 11 AC Fail

212 10 21 Battery Fault

213 11 40 All Fault

214 12 12 Tamper Alarm

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 95 96

Sin comentarios

Cooper Security 9751 Guía de usuario Pagina 63