Cooper Security 9751 Guía de usuario descargar pdf (Pagina 20)

2. Programming Commands

Page 14 497096, issue 3

21: Zone Configuration

This command enables you to select the wiring type of the zone connectors

on the control unit PCB. The default is option 0 for all models.

Zones type on 9751/2 PCB

0 Up to 8 closed circuit loop zones (CC + Com A/T).

1 Up to 8 fully-supervised loop zones (FSL 2K2/4K7)

Zones type on 9853 PCB

0 Up to 8 closed circuit loop zones (CC 4 wire).

1 Up to 8 end-of-line zones (EOL 2K2)

2 Up to 16 fully-supervised loop zones (FSL 2K2/4K7). This setting

enables up to 24 zones to be connected to expanders.

3 Up to 8 fully-supervised loop zones (FSL + EXP). This setting enables

up to 32 zones to be connected to expanders.

Note:

1. Compliance with PD 6662 / prEN 50131-1: 2004 (see page 85) at Grade 3 (9853

units only) requires that Command 21 is set to one of the Fully Supervised Loop

options (2 or 3).

2. Using three-resistor anti-mask wiring (9853 units only) requires that Command 21 is

set to one of the Fully Supervised Loop options (2 or 3).

You can connect more zones using expanders. The maximum number of

zones depends on the type of control unit. Refer to the Installation Guide for

details.

22: Loudspeaker Chime

In a single system, a user may find that the Chime tone from the keypads is

not loud enough. If so, use this command to make the internal sounder give

the Chime tone as well. If you select option 0, the internal sounder emits no

tone. Select a value from 1 (quietest) to 9 (loudest) to set the Chime volume

(the default is 5). The internal sounder demonstrates the volume when you

enter the digit.

Note: In a partitioned system, this command is available only for Partition A.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 95 96

Sin comentarios

Cooper Security 9751 Guía de usuario Pagina 20