
2. Programming Commands
497096, issue 3 Page 51
131: SIA Report Mode
SIA reports are called telegrams. Each telegram contains the site
identification number (normally six digits) and relevant event information. The
amount of information reported depends on the SIA mode that you select:
Basic, Summary, Intermediate or Full. The following table shows the types of
report for each mode; use this to decide which mode is appropriate for the
installation. Each mode also contains all the reports in the mode above it.
Option
0 Basic (default)
1 Summary
2 Intermediate
3 Full
The system also provides a "custom" mode, which allows any combination of
event information, but you have to use Downloader to create the required
combination.
Note: The control unit delays reporting/logging either mains loss, or exiting engineering
with mains loss, by 15-18 min (chosen at random). The control unit delays
reporting/logging either mains restore, or exiting engineering with mains restored,
by 60-90 sec (chosen at random). If you select a Scandinavian default in Command
0, the control unit waits at least 60 minutes before reporting.
BASIC
Event SIA Code CID Code
ALARM CONFIRM BV 139
BURG BA 130
BURG RESTORE BR 130‡
DURESS HA 121
DURESS RESTORE HR 121‡
EXIT TIMEOUT EA -
EXPANDER TAMPER TA 137
EXPANDER TAMPER RESTORE TR 137‡
FIRE FA 110
FIRE RESTORE FR 110‡
FORBI INTERFACE TAMPER TA 137
FORBI INTERFACE TAMPER RESTORE TR 137‡
FORBI LOOP TAMPER TA 137
FORBI LOOP TAMPER RESTORE TR 137‡
FORBI TAMPER TA 137
FORBI TAMPER RESTORE TR 137‡
GLOBAL TAMPER TA 137
GLOBAL TAMPER RESTORE TR 137‡
KEYBOX OPEN BA 150
KEYBOX CLOSED BR 150‡
Comentarios a estos manuales