Cooper Security 9751 Guía de usuario descargar pdf (Pagina 48)

2. Programming Commands

Page 42 497096, issue 3

102: Communication Fault Timeout

This command sets the period after which a communications fault times out.

In earlier versions of the 9x5x series, timeouts occurred after a specified

number of calls.

Option

0 60 seconds

1 120 seconds

2 240 seconds (default)

3 480 seconds

Note: Compliance with PD 6662 / prEN 50131-1: 2004 (see page 85) requires that

Command 102 is set to option 2.

103: Reporting Type

The system supports several message formats for communications:

Option

0 Scancom Fast Format (FF) (default)

1 Contact ID (CID)

2 Scancom SIA Level I (SIAI)

3 Scancom SIA Level II (SIAII) – this does not send time and date

4 Scancom SIA Level 3 (SIA3)

5 Extended Scancom SIA Level 3 (XSIA3)

6 Home "beep" (Home)

Option 6, Home "beep", is not a particular message format. What it means is

that the communicator dials a number and sends a "beep" down the line. This

does not allow a complex message to be sent but means that the person

answering the call needs no special equipment to decode the message. The

number of times the communicator repeats the Home "beep" is set with

Command 186. For the 9853 only, the receiver can press 5 on the telephone

keypad to acknowledge the alarm and terminate the series of calls.

104: Not used

This command is not used.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 95 96

Sin comentarios

Cooper Security 9751 Guía de usuario Pagina 48