
2. Programming Commands
Page 32 497096, issue 3
69: Forbikobler Door Locking
This command specifies whether the door controlled by the Forbikobler
system is normally unlocked while the system is reset or opened only for a
controlled time. Even if the door is normally unlocked, it can be locked with a
user command if required.
Option
0 Lock Timed (default)
1 Lock Toggled
70: Level C Final Exit Operation
In a single system, this command specifies how the system treats Final Exit
zones during part set C. If you select option 0 (the default), any Final Exit
zones in Level C continue to act as Final Exit zones during part set C. If you
select option 1, these zones act as Normal Alarm zones during part set C.
Note: This command is not available in a partitioned system.
71: Level C Entry Route Operation
In a single system, this command specifies how the system treats Entry Route
zones during part set C. If you select option 0 (the default), any Entry Route
zones in Level C continue to act as Entry Routes during part set C. If you
select option 1, these zones act as Final Exit zones during part set C.
Note: This command is not available in a partitioned system.
72: Level/Partition C Exit Mode
This command sets the Exit Mode for Level or Partition C. The keypads give a
double "beep" confirmation tone at the end of all setting modes, including
Silent Set. The default is option 0, Timed.
In a single system, the options are:
Option
0 Timed. The keypad sounders and any internal sounders give a low
tone during exit of Level C. Use Command 75 to select the exit time.
1 Instant Set (no exit tone). Use this option to make the system set
without delay or exit tone.
2 Silent Set. Use this option to make the system set without an exit
tone. Use Command 75 to program the exit time.
3 Makes the Level C exit mode the same as Level A.
Comentarios a estos manuales