Cooper Security 9853 Guía de instalación descargar pdf (Pagina 88)

4. Programming

82 496791

Partition Programming

Introduction

When programming the 9851 there are two ways of changing the control unit

from a single system to a partitioned system: a) during initial power up or b)

by using Command 98.

To create a partitioned system during initial power up see page 28.

If you have an existing 9851 that has already been programmed as a single

system, and wish to convert it to a partitioned system, then:

1. Enter programming mode (if you are not already there).

2. Key in 98 at the keypad.

The display shows:

3. Press 1 at the keypad.

The display shows (for example):

4. Either: Press 1 to create a partitioned system

Or 0 to create a single system.

The display shows (for example):

5. Press .

The keypad gives a double confirmation tone and the system loads the

factory default Command values, erasing all previously programmed

values.

Notes:The log is protected and cannot be erased by the Installer.

Partition Programming

Once you have changed a 9851 into a partitioned system then you can use

the following Commands to program each partition:

1. Use Commands 01 to 16 and 17 to 40 to assign each zone to a

Partition.

Each zone defaults to Partition A.

Use 5 to assign zones to Partition B.

Use 6 to assign zones to Partition C.

Use 8 to assign zones to Partition D.

2. Use Command 32 to assign each keypad to a Partition as required. By

default all keypads belong to all Partitions.

3. Program the exit mode, alarm response, entry time and exit time for

each Partition as follows:

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 101 102

Sin comentarios

Cooper Security 9853 Guía de instalación Pagina 88