Cooper Security 9853 Guía de instalación descargar pdf (Pagina 63)

4. Programming

496791 57

Option 0 Keypad sounders only.

Option 1 Local alarm (internal and external sounder only).

Option 3 Full alarm (communication and internal/external sounders).

Note that this Command is not available for single systems.

Lockout Keypads During Entry (Command 48)

This Command is intended to make the system comply with DD243: 2002

6.4.5. If you want the user to unset the system by means of a portable ACE

(for example the 725r telecommand) then the keypads must be locked out

during entry.

Option 0 enables all users at all keypads during entry, option 1 locks out

users from keypads during entry.

On a partitioned system individual user access codes are locked out depend-

ing on which partition they are assigned to.

When you lockout keypads during entry, various functions are still available:

• Keypad PA, Fire and Medical alarms.

• Duress codes remains active at all times.

• During an alarm the user is not locked out, they can cancel false alarms

or disarm the system.

CSID Code (Command 50)

To allow the customer to use the ‘Remote Reset’ facility, you must program

the control unit as ‘Engineer Reset’ (Command 33 option 1) and then install a

four digit Central Station Identification (CSID) code.

First make contact with the ARC and obtain the CSID code. Then ensure that

the system is in programming mode. Next, key in:

50 nnnn

Where nnnn is the "CSID Code".

The control unit now contains the same CSID code as the ARC. After an

alarm the control unit can generate a ‘Reset Code’ which will be recognised

by the ARC 7300 Remote Reset decode programmer.

After an alarm the user keys in their access code to silence the alarm, but

cannot reset the system. The system generates a four digit code number and

displays it on the keypad. The user calls the ARC and tells them the number

shown on the keypad display. The ARC verifies the user's identity, then

enters the code number into a special programmer. The programmer gener-

ates an ‘Anti Code’, which the ARC gives back to the user. The user then

enters the ‘Anti Code’ at the keypad to reset the system.

Note: To delete a CSID code key in “0000” over the existing code.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 101 102

Sin comentarios

Cooper Security 9853 Guía de instalación Pagina 63