Cooper Security i-on 16 Guía de usuario descargar pdf (Pagina 6)

Introduction i-on16

Page 2

End Station and Keypad

Opening the End Station Case

WARNING: When connected to the mains with power

applied mains voltages are present on the shrouded

heads of the terminal screws of the mains connector (“7”

in figure 1).

To gain access to the interior of the end station undo the

two screws at the top of the case. Pull the top of the lid

down, and then lift the lid out of the retaining lugs at the

bottom of the case (see Figure 1.)

Figure 1 shows the interior of the end station.

1. Central fixing keyhole. 6. Transformer.

2. Aerials. 7. Mains connector block.

3. Fixing holes. 8. Cable entry hole for mains.

4. Printed circuit board (PCB). 9. Back Tamper switch (if fitted).

5. Cable entry holes for pcb. 10. Connector pins for Lid Tamper.

Figure 1. Control Unit

1 2 3 4 5 6 7 8 9 10 11 ... 67 68

Sin comentarios

Cooper Security i-on 16 Guía de usuario Pagina 6