Cooper Security i-on 16 Guía de usuario descargar pdf (Pagina 29)

i-on16 Installation

Page 25

Note that the alert LEDs round

the navigation glow red. This is

because the end station lid is off

and the tamper is active.

7. Remove both battery and mains

power.

Re-apply battery power followed

by mains.

The sounders stop.

At this point you can carry on to commission the system.

See below.

Note: Setting the time and date is an administrative user

function. See i-on16 User Guide for instructions.

8. Commission the System

After installing the control unit you should commission

the alarm system as follows:

1. Use the Installer Menu (see Chapter 4) to teach the

control unit the identity of its radio detectors and any

other peripherals. See the installation instructions

supplied with each detector or peripheral.

2. Install detectors and peripherals at their selected

locations.

3. Use the Installer Menu – Testing (see Chapter 5) option

to:

a) carry out a walk test of the detectors.

b) test the operation of any other peripherals.

4. Program the system to suit user requirements.

5. If necessary, record speech messages on the I-SD01

and test them (see page 52 ).

6. Assemble and close the end station:

a) Hook the lid of the control unit into the bottom of

the back box.

b) Close the lid and then tighten the two fixing

screws.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 67 68

Sin comentarios

Cooper Security i-on 16 Guía de usuario Pagina 29