Cooper Security i-on 16 Guía de usuario descargar pdf (Pagina 32)

Programming i-on16

Page 28

in a total of ten incorrect codes (13 consecutive

digits) then the system locks you out for 90 seconds.

Leaving the Installer Menu

If you wish to leave the Installer Menu at any time.

1. Press

X until the display shows

the words “Leave installer

mode?”.

Leave

installer mode ?

2. Press Y. to leave Installer

menu.

(Press X if you do not want

to leave the menu.)

The display shows the time and

date. The system is ready for

use.

i-on16

12:00 02/01/2008

Note: If you attempt to leave the Installer Menu when a

detector tamper is active then the keypad displays a

fault message telling you which detector is causing

the problem. Press

to return to the Installer Menu.

You must either close the detector tamper or delete

it from the system before you can leave the Installer

Menu.

Restoring the Access Codes (1

stage Reset)

If the user and/or Installer codes are lost then:

1. If possible, enter the Installer menu.

Note: If you cannot enter Installer Menu then the end

station will start a tamper alarm when you open the

end station lid.

2. Remove mains power, then open the case and

disconnect the battery .

3. Identify the Reset Codes pins on the main PCB (see

Figure 2).

4. Short the Reset pins together using a small wire link.

5. Apply mains power.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 67 68

Sin comentarios

Cooper Security i-on 16 Guía de usuario Pagina 32