
i-on16 Programming
Page 45
There are three options available:
Off
The remote control user cannot force set the system,
even if you have applied the force set zone attribute
to any zones.
Confirm
The remote control user can force set the system.
They must operate as follows: 1) the user presses the
appropriate button to set the system, 2) the control
unit does not start setting, 3) the user presses the
same remote control button to confirm that they wish
to continue setting the system.
On
The user need only press the remote control button
once to complete setting the system.
Silence Alerts
This option controls the length of time that the keypad
gives the alert tone (a brief ‘beep’ every few minutes)
when there is an alert. The options are:
User The keypad gives the tone until a user keys in their
access code to acknowledge the alert.
30, 60, 120 minutes The keypad gives the alert tone for
the selected time.
No Alert Tones The keypad gives no alert tone. (The red
LEDs around the navigation key glow to show that there
is an alert.)
Reporting
Note: The control unit hides this menu option if there is
no I-SD01 fitted in the end station.
The Reporting option in the Installer Menu contains all the
options needed to program how the control unit will
communicate alarms. Within the Reporting options, the
main menu item deal with the following areas:
Alarms
Deals with reporting to a central station using either
CID or Fast Format.
Comentarios a estos manuales