Cooper Security 9751 Guía de instalación descargar pdf (Pagina 49)

4. Programming

496792 43

To change: Key-in: Notes Default

Note: The following Commands are available if you select option 1 for Com-

mand 89.

Confirm Timer 160 nnn

nnn is a time in the range 001 to 999 minutes. Default 030 minutes.

Internal Sounder 161 0 Sounder on Unconfirmed Alarm Y

1 Sounder on Confirmed Alarm

External Sounder 162 0 Sounder on Unconfirmed Alarm Y

1 Sounder on Confirmed Alarm

Confirmation After Entry 163 0 Never Y

1 One Zone

2 Two zones

User Reset After 164 0 Disabled Y

Confirmed Alarm 1 Enabled

Leaving Programming Mode

When all programming has been completed:

1. Key-in ‘99 ’ at the keypad

The display shows:

2. Press .

The display shows:

followed by the time and date.

The system is now in user mode.

Note: If there is a fault on the system , for example an open tamper circuit, the

display shows this and will not return to Day mode. Press and rectify the

faults.

Engineer Reset

To perform an Engineer Reset:

1. Check that the display is showing the alarm condition.

2. Key in 0 followed by the Engineer’s code (default 7890), followed by 99 .

The display shows the time and date.

Re-entering Programming Mode

You can go back into programming mode whenever the system is unset and

not in alarm:

1. Key in 0 followed by the Engineer’s code (default 7890).

The display shows:

You are now in programming mode.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 95 96

Sin comentarios

Cooper Security 9751 Guía de instalación Pagina 49