Cooper Security 9651 Guía de usuario descargar pdf (Pagina 16)

11980075 Page 16

3. After an Alarm

Responding to a Fire Alarm

IMPORTANT: The system gives a fire alarm by

sounding a two-tone warning from the keypads and

alarm sounder. The display shows (for example):

Fire Z02 Alarm

9x5x

1. Evacuate the premises.

Do not attempt to unset the alarm.

2. If there is evidence of fire, call the Fire Brigade.

3. Only when the premises are safe, proceed as for

other alarms.

Responding to other Alarms

When your system raises an alarm other than a fire alarm, you must:

• Unset the system as normal to switch off the sounders and strobes.

• Reset the system ready for further use.

The system logs the zone (or zones) that triggered the alarm and displays

alerts on the keypad display. The first zone is shown automatically when you

unset the system. View the others by pressing Y to accept the Next prompt.

For instructions on viewing and acknowledging alerts, see page 18.

Your system may be configured for various types of reset:

• User reset. Enter your access code (or present your tag) again to reset

the system. The system gives a double "beep" to confirm that it has reset.

• Installer reset. If the display shows "Call Installer", contact your alarm

company to arrange a visit.

• Remote reset. If the display shows a reset code, write down the code

and call your ARC. You will be asked to verify your identity, the

circumstances and the code. If no intervention is required from an

installer, you will be given a code to enable you to reset the system.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sin comentarios

Cooper Security 9651 Guía de usuario Pagina 16