Cooper Security 9651 Guía de usuario descargar pdf (Pagina 14)

2. Everyday Operation

Page 14 11980075

Unsetting the System

WARNING: If you enter your premises and an internal alarm

starts, there may be an intruder.

You can unset the system from a keypad or keyswitch.

When you open an entry door, the system starts an entry timer. There are four

entry timers so that different entrances can use different times. During the

entry time, the keypads give a "galloping" entry tone to warn you that the timer

is running. If you exceed the entry time, an alarm will occur. Your installer will

have ensured that the entry time for each entrance is long enough for you to

enter by the designated entry route, get to the keypad and unset the system.

If an entry door is fitted with a lock switch, the keypad gives a continuous exit

tone when you unlock it and, if you lock it again, the system remains set; it is

only when you open the entry door that the entry timer starts and the keypads

give the entry tone.

General Procedure

To unset the system:

1. Enter through the designated entry door

and go to the keypad.

As you enter the premises, the system

starts the entry timer and the keypads

give the entry tone.

2. Key in an access code (or present a tag).

All set levels are unset.

The entry tone stops and the system

gives a double "beep".

The system is now unset.

Keyswitch Unset

If your system is fitted with a keyswitch, you can use it to unset Level A. With

a three-position keyswitch, switching from Part to Off unsets Level B. You do

not need to enter an access code or present a tag.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Sin comentarios

Cooper Security 9651 Guía de usuario Pagina 14