Cooper Security i-on40 Manual de usuario descargar pdf (Pagina 30)

Administration i-on40

Page 26

Note: The internal clock adjusts itself for daylight saving in Spring

and Autumn.

Programming Outputs

During programming the installer may allocate some outputs so

that they can be reprogrammed by an Administrator. This section

describes how the Administrator can use those outputs.

For each output you can, if you wish, set and “on” time and an

“off” time so that the output will go on and off at fixed times each

day. In addition, Master, Admin and Normal users can switch the

output on or off at any time.

To program an output:

1. In the User Menu select System Config - Edit Outputs.

The display shows the Edit Output menu, the bottom line

shows the first in a list of the available outputs.

Note: This option is only visible if the installer has allocated some

outputs to you.

2. Press u or n to select the output you wish to edit then press

The bottom line of the display shows “Name”, the first item

in a menu that allows you to change the name of the

selected output, and to set an “On” and “Off” time for the

output.

3. Press u or n followed by > to select Name to give the

output a meaningful name. (Hint: see Editing Text on page

14.)

The name you give the output appears in all the other menus

the display offers for controlling outputs.

4. Press u or n followed by > to select “On Time” to set a time

when the control unit will switch the output on.

5. Press u or n followed by > to select “Off Time” to set a time

when the control unit will switch the output off. If you do not

wish the output to switch on and off at set time then leave

these two options set to “00:00”.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36

Sin comentarios

Cooper Security i-on40 Manual de usuario Pagina 30