Cooper Security i-on40 Manual de usuario descargar pdf (Pagina 15)

i-on40 Alarms

Page 11

The siren stops and the screen

shows the first zone to cause

the alarm, for example:

(Press u or n to see the name

of the zone.)

2. Press Y.

The display returns to normal.

Press tick to reset

Burg Z03 Alarm

If you return to the control unit after the sirens have stopped and

key in your access code then the red LEDs around the navigation

keys glow to tell you that an alarm has occurred. Press > to see

information about the alarm. (Press u or n to see the name of

the zone.) Press Y to restore the display to normal.

If you wish to see any other zones that were triggered during the

alarm, look in the log (see page 22).

Remote Reset (aka Anti-Code Reset)

The installer may have programmed your system so that you

cannot reset after an alarm.

The screen will tell you where the

alarm occurred, for example:

Press tick

Burg Z03 Alarm

It will also show a message asking

you to call the alarm company, for

example:

CALL ARC

Quote 1234

The number displayed on the bottom line is a special code

(“1234” is just an example). Note this code down, you will need it

when you talk to the alarm company.

Press Y to clear the message and the display returns to normal.

Call your alarm company and tell them that an alarm has

occurred.

When you talk to the alarm company, they will ask about the

circumstances of the alarm, and also for the code you recorded

from the display. If the alarm company decides that an engineer

does not need to visit you, then they will give you another four

digit code (the “anti-code”).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Sin comentarios

Cooper Security i-on40 Manual de usuario Pagina 15