Cooper Security i-on40 Manual de usuario descargar pdf (Pagina 20)

Administration i-on40

Page 16

2. Press u or n to display the zone you wish to omit.

3. Press > to mark the zone for omission.

The character at the end of the line changes to an "O" to

show that the zone will be O

mitted.

If you change your mind then press > again so that the end

of the line shows an "I" (for I

ncluded).

4. Repeat steps 2 and 3 for any other zone you wish to omit (or

include).

5. Press Y to store the changes you have made.

The control unit allows you to omit a zone for one

setting/unsetting cycle. You will have to omit the zone again for

the next setting/unsetting cycle.

Users

The control unit can recognise up to 50 individual users. Select

Users in the Menu to add new users, change their details, or to

delete them from the system.

Editing Existing Users

If you wish to change the details for an existing user then:

1. Enter the Menu and select Users - Edit User.

The bottom line of the display shows the first in a list of the

users already programmed into the control unit.

2. Press u or n to display the user you wish to edit, and then

press >.

The bottom line shows one of a list of the options that you

can edit:

Name: Use this option to give the user a 12 character name.

The display will show the name in menus, and in the log

when the user sets, unsets or resets the system.

Type: (Not available for User 01) Master, Admin, Normal,

Guard or Set Only.

Partitions: (Not in a part setting system) Use this option to

assign users to one or more partitions.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Sin comentarios

Cooper Security i-on40 Manual de usuario Pagina 20