Cooper Security 9651 Manual de instalación descargar pdf (Pagina 67)

9651 Programming - Programming Commands

11772232 Page 63

159: Invert Plug-by Outputs

By default, plug-by outputs have a positive voltage when inactive and this is

removed when the output is active. This command inverts that logic so that a

positive voltage is applied when the output is active.

Option

0 +ve removed to trigger (default): the output is positive when inactive

and goes to zero when active.

1 +ve applied to trigger: the output floats when inactive and goes

positive when active.

170 to 175: Pulse Output Programming

You can program the panel outputs to generate a pulse of a defined length

when triggered by a set or unset event. Pulses of different lengths can be set

for each level. Commands 170 to 175 enable you to configure these pulse

outputs. Press y to move between the outputs within each command.

Command Value Default Description

170 00* to 12 01 Specifies the length in seconds of the pulse to

be generated on setting.

* A value of 00 latches the output.

171 A/B/C/D abcd Assigns each pulse set output to one or more

levels.

172 00* to 12 01 Specifies the length in seconds of the pulse to

be generated on unsetting.

* A value of 00 latches the output.

173 A/B/C/D abcd Assigns each pulse unset output to one or more

levels.

174 0 (Off) or 1

(On)

On Specifies whether each pulse unset output is

activated for a Fire alarm.

175 0 (Off) or 1

(On)

On Specifies whether each pulse unset output is

activated for a PA.

Notes:

1. Generating a pulse on an output depends both on a set or unset pulse

being defined for the output and on the output being associated with a

level that is being armed or disarmed.

2. Commands 174 (Fire) and 175 (PA) activate only the Pulse Unset

outputs configured with Command 172.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 87 88

Sin comentarios

Cooper Security 9651 Manual de instalación Pagina 67