Cooper Security i-on160EX Manual de usuario descargar pdf (Pagina 32)

3. Setting and Unsetting i-on40 & i-onEX Range

Page 26

Note: If a Partition is Full Set then

you cannot go directly to

Part Set. You must unset

the Partition first. If the

Partition is Part Set then

you cannot go directly to

Full Set. You must unset the

Partition first.

f. Press .

Go to: 3. Finishing Setting

below.

3. Finishing Setting

Depending on how your installer has programmed your system,

you will need to take one of the following actions to complete

setting the system. Note that you will need a special button fitted

in order to use Exit Terminate Set, and a special lock fitted to use

Lock Set.

Instant Set/Silent Set:

Note: Make sure you are outside

the protected area before

taking the next step. Instant

set does not have any exit

time.

a. The keypads give a double

“beep” and the system sets

immediately.

Timed Exit:

a. The keypad sounds the exit

tone (a continuous tone). The

top line of the display shows

the part of the system being

set, the bottom line shows

the remaining exit time (in

seconds).

If you hear an interrupted





1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 121 122

Sin comentarios

Cooper Security i-on160EX Manual de usuario Pagina 32