Cooper Security i-on160EX Manual de usuario descargar pdf (Pagina 18)

1. Introduction i-on40 & i-onEX Range

Page 12

Remote Controls

A remote control is a transmitter that you can attach to a key

ring. The remote control has four buttons and a small LED that

glows when it transmits a signal.

Note that to prevent accidental operation the user must hold a

button down for at least two seconds to ensure a transmission.

When delivered from the factory three of the buttons are

dedicated to setting or unsetting the system (see Figure 3).

1. Full Set.

2. Part Set.

3. (Programmable, see

page 95.)

4. Unset.

5. Transmit LED.

Figure 3. Remote control Buttons.

Each remote control has a unique electronic identity. When you assign

a remote control to a user you teach the identity to the control unit.

You may assign one (and only one) remote control to each user.

TwoWay Key Fob

The two-way keyfob, FOB-2W-4B, is a remote control designed to

give you confidence that your alarm system has set or unset

correctly. When you operate the buttons on the fob, the control

unit sends back signals which light up one or more LEDs on the

fob to let you know what is happening. The LEDs can show

whether your system has set or not, or if there has been an alarm

while you have been away.

Figure 4 shows you where they are.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 121 122

Sin comentarios

Cooper Security i-on160EX Manual de usuario Pagina 18